**
Inorder to maintain proper performance of the product, it is essential to have the most up to date software. The latest
newsand release of software versions may be found at Humax website - http://www.humaxdigital.com.
Itis recommended that you periodically check for the availability of software upgrade.
11.1 OTA (Over the Air)OTA,an abbreviation of "over the air", means downloading the software where the manufacturer reserves the right to
decidewhen and where to release through aerial.
Overthe Air(OTA) is simply another alternative for downloading software versions. However, the manufacturer reserves
theright to decide when and where this software update can take place by "beaming" latest software versions over the
airvia aerial. The software update via aerial will only occur under the following circumstances.
1. The equipment should have appropriate loader software.
Caution: Pleasenote that if you don't have normal loader software, the equipment may not be updated or
workafter software update.
** 2. The manufacturer decides to release software downloading via a designated aerial.
3. The equipment must be "tuned" properly to the same aerial that the manufacturer uses.
4. Update software when the quality of receiving signal strength is high. if the quality of receiving signal strength is
notrecommendable due to bad weather, upgrade the software later.
**
Caution:
• Pleasebe careful to keep the power on and the power cord plugged in during software update. If the power is off
duringsoftware update, it may cause fatal damage to the product.
• Pleasebe careful not to pull out the Signal line (co-axial Cable) during software update. Update may be
interruptedand the product may not work.
**
Note:
• Theproduct cannot work at all during software update.
• Itmay take 5 ~10 minutes to update software.
• Schedulingoperation cannot work during software update.
1. If new software is found when powering on
1. A message will be displayed to notify that new software is found.
2. Select Yes and press the OK button to update the software.
3. Starts downloading new software. Please wait until the update is completed.
4. When completing the software update, the equipment is automatically powered off and on again.
11. Software Update