Water Type, Alarms Menu Tab | Humminbird 141c manual

531442-1_A_141c_Eng.qxd 11/15/2005 8:39 PM Page 38

Water Type

(Advanced)

Water Type configures your unit for operation in fresh or salt water. The Water Type menu choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).

NOTE: In salt water, what would be considered a large fish might be 2 to 10 times bigger than a large fish in fresh water (depending on the type of fish you are seeking). The salt water setting allows for a greater range in fish size adjustment to account for this. Also, make sure that the Water Type is set accurately, especially in salt water, as this affects the accuracy of deep water depth readings.

Alarms Menu Tab

From any view, press the MENU key twice to access the Main Menu System. The Alarms tab will be the default selection.

NOTE: When an alarm is triggered, you can silence it by pressing any key. The alarm will be silenced, and will not be triggered again until a new instance of the alarm condition is detected.

To change the Water Type setting:

1. Make sure you are in Advanced User Mode, then highlight Water Type on the Sonar main menu.

2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Water Type setting. (Fresh, Salt, Default = Fresh)

Alarms Menu

33

34

Image 20

Humminbird 141c manual Alarms Menu Tab, To change the Water Type setting

Contents

141c Operations Manual Table of Contents Thank You Table of Contents Single Beam Sonar Peak to Peak measures power output at the highest pointsHow Sonar Works What’s On the Display High Sonar Intensity Return Bait Ball Views Sonar ViewSonar View Zoom View Big Digits View Circular Flasher View Sonar View Bottom Presentation Understanding Sonar HistoryReal Time Sonar RTS Window Sonar Zoom View Sonar Zoom View POWER/LIGHT Key Big Digits ViewKey Functions Circular Flasher View Menu Key WAY Cursor Control KeyExit Key Owering Up the Unit Press TM Menu Sonar Tab, Normal Mode Sonar Tab, Advanced ModeMenu System Simulator Start-Up Options MenuNormal Operation Accessory Test System Status Sonar X-Press TM MenuConduct a unit self-test Status To adjust the Sensitivity To adjust the Upper RangeSensitivity Upper Range Zoom Level Chart SpeedLower Range To adjust the Bottom Range Bottom LockBottom Range Sonar Menu Tab To change the Fish ID Sensitivity setting To change the RTS Window settingFish ID+TM Fish ID Sensitivity Depth Lines Bottom ViewZoom Width Max Depth Surface ClutterNoise Filter Alarms Menu Tab To change the Water Type settingAlarms Menu Water Type Depth Alarm Fish ID AlarmLow Battery Alarm Temp Alarm Alarm Tone Setup Menu TabTo change the Alarm Tone setting Highlight Alarm Tone on the Alarms main menu User Mode Units DepthUnits Temp Units Distance Select Views Triplog ResetRestore Defaults Temp Offset Select ReadoutsDepth Offset Troubleshooting To change the Speed Calibration settingSpeed Calibration Advanced, with Temp/Speed only Display Problems Problem Possible CauseControl head loses power at high speeds Finding the Cause of Noise Sonar Terms SpecificationsGlossary 531442-1A141cEng.qxd 11/15/2005 840 PM Receiver See Transmitter 531442-1A141cEng.qxd 11/15/2005 840 PM 531442-1A141cEng.qxd 11/15/2005 840 PM Contact Humminbird