Humminbird ID 600 guide

mounting bracket. Drill this hole and install the screw after final testing and adjustments have been completed.

Image 9

Humminbird ID 600 manual

Contents

Page Accessories Installation OverviewParts Supplied Determining How to Mount the Transducer Portable Mounting Alternate Transducers and Mounting MethodsTrolling Motor Mounting Thru-Hull Mounting Transducer Exchange Beginning Installation Step One Determine Where to Mount the Transducer Transom Installation Step Three Assemble the Transducer Step Two Drill the Mounting Holes Step Five Adjust the Running Position of the Transducer Step Four Mount the Transducer to the TransomConfirm the pivot angle has not changed Page Step Six Route the Cable Inside the Hull Installation Step One Determine the Mounting LocationStep Two Test the Mounting Location Page Step Three Permanently Mount the Transducer Control Head Installation Step One Determine Where to MountStep Two Connect the Power Cable to the Boat Page Step Four Run the Cables Step Three Drill the Mounting HolesPage Your Humminbird is now ready for operation Step Five Assembling the Connector Holder Test the Installation Gimbal Mount Installation Installing the SeaScope ID600 Testing the Installation Using the SeaScope ID600 Using the Built-In SimulatorOperating the SeaScope ID600 Sensitivity Factory setting +0/FEET Fish Alarm Bottom Alarm Bottom Lock Zoom Display Speed Fish ID Depth Range