Manuals / Hunter Fan / Kitchen Appliance / Ventilation Hood

Hunter Fan 82048 manual 43042-01 02/21/2008, English, Secure the motor by tightening the 2 screws

Models: 43042-01 82048

1 21

Page 10

Secure the motor by tightening the 2 screws.

B20 Turn on the power source. Manual background B21

F


G
Install the wiring cover plate. Make sure all wiring	Connect 4” duct and vent to the outside. Tape joints.
connections are inside the box or under the	If ducting does not fit securely, an adapter may need
wiring cover plate.		to be purchased.
B22	B22

ENGLISH

Connect wiring from the motor to the wiring cover plate.

Reinstall the motor by inserting the tabs and pushing up into

position. Make sure the wires are not pinched

between the motor and the housing.

B24	B25
I
Secure the motor by tightening the 2 screws.	Turn on the power source.

43042-01 02/21/2008

Page 10

Image 10

Hunter Fan 82048 manual 43042-01 02/21/2008, English, Secure the motor by tightening the 2 screws, Turn on the power source

Contents

READ and SAVE THESE INSTRUCTIONS I n s t a l l a t i o nG u i d e 82048 Turino Bath Ventilator with LightDISCONNECT ELECTRIC POWER SUPPLY AND LOCK OUT SERVICE PANEL BEFORE PREVENTATIVE MAINTENANCEMAINTENANCE Do Not Install AboveCheck all the parts x4 Afor replacements If damaged, callRemove the motor/blower from the housing Before InstallationTurn off the power source with the side of the housingChoose Installation Option 43042-01 02/21/2008 New Construction - attaching to joistENGLISH 43042-01 02/21/2008 New Construction - suspended between joists Go to stepon page to attach grille Mark position of screws by using holes as a templateAttach the rails onto the screws Connect wires as shown43042-01 02/21/2008 H IS GLNEENGLISH Turn on the power source43042-01 02/21/2008 Secure the motor by tightening the 2 screwsNO EXISTING FAN Existing Construction - accessible from aboveC11 EXISTING FAN Cut out an opening for the housing43042-01 02/21/2008 Mark position of screws by using holes as a template1/8 Bit Position the correct depth mark at the bottom edge of the joist43042-01 02/21/2008 GLNE43042-01 02/21/2008 ON OFFENGLISH Pull wires through strain relief Existing Construction - accessible only from belowD11 EXISTING FAN Attach existing ducting to duct connector. Tape joints43042-01 02/21/2008 ENGLISHon page to attach grille Turn on the power sourceGo to step ON OFF43042-01 02/21/2008 ENGLISHAttach thumbscrews Install 2 Max 60 Watt A15 bulbs Not Included43042-01 02/21/2008 Screw glass stop into positionTrouble Shooting 43042-01 02/21/2008Warranty 43042-01 02/21/2008

Secure the motor by tightening the 2 screws.

Turn on the power source.