Manuals / Hunter Fan / Kitchen Appliance / Ventilation Hood

Hunter Fan 43042-01 02/21/2008, Attach thumbscrews, Screw glass stop into position, H Is, Ngle

Models: 43042-01 82048

1 21

Download 21 pages 35.99 Kb

Page 19

Image 19

Attach thumbscrews.

WARNING: To reduce the risk of electrical shock, all 4 thumbscrews MUST be properly installed.

Screw glass stop into position.

E11

Screw Finial into position

Install 2 Max 60 Watt A15 bulbs (Not Included).

E10			H IS

			NGLE
			NGLE

Align glass dome and push up.

E12

Complete.

43042-01 02/21/2008

Page 19

Image 19

Hunter Fan 43042-01 02/21/2008, Attach thumbscrews, Screw glass stop into position, Screw Finial into position, H Is

Contents

82048 Turino Bath Ventilator with Light I n s t a l l a t i o nG u i d e READ and SAVE THESE INSTRUCTIONSDo Not Install Above PREVENTATIVE MAINTENANCEMAINTENANCE DISCONNECT ELECTRIC POWER SUPPLY AND LOCK OUT SERVICE PANEL BEFOREIf damaged, call x4 Afor replacements Check all the partswith the side of the housing Before InstallationTurn off the power source Remove the motor/blower from the housingChoose Installation Option 43042-01 02/21/2008 New Construction - attaching to joistENGLISH 43042-01 02/21/2008 Mark position of screws by using holes as a template Go to stepon page to attach grille New Construction - suspended between joistsH IS GLNE Connect wires as shown43042-01 02/21/2008 Attach the rails onto the screwsSecure the motor by tightening the 2 screws Turn on the power source43042-01 02/21/2008 ENGLISHCut out an opening for the housing Existing Construction - accessible from aboveC11 EXISTING FAN NO EXISTING FANPosition the correct depth mark at the bottom edge of the joist Mark position of screws by using holes as a template1/8 Bit 43042-01 02/21/2008GLNE 43042-01 02/21/200843042-01 02/21/2008 ON OFFENGLISH Attach existing ducting to duct connector. Tape joints Existing Construction - accessible only from belowD11 EXISTING FAN Pull wires through strain reliefENGLISH 43042-01 02/21/2008ON OFF Turn on the power sourceGo to step on page to attach grilleENGLISH 43042-01 02/21/2008Screw glass stop into position Install 2 Max 60 Watt A15 bulbs Not Included43042-01 02/21/2008 Attach thumbscrews43042-01 02/21/2008 Trouble Shooting43042-01 02/21/2008 Warranty

Attach thumbscrews.

Screw glass stop into position.

Screw Finial into position

Install 2 Max 60 Watt A15 bulbs (Not Included).

NGLE

Align glass dome and push up.