B23 | B24 |
Existing Construction – accessible from above |
| |
C11 | EXISTING FAN | NO EXISTING FAN |
OR
Connect wiring from the motor to the wiring cover plate.
H
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
Remove an existing fan and check to make sure the | Use the motor housing as a template to mark position. |
opening is large enough to accommodate the new |
|
motor housing (9” x 9.75”). |
|
B25 |
I |
Secure the motor by tightening the 2 screws.
B26 |
Turn on the power source.
|
|
| 5” |
|
| 7 | |
9” | . |
| |
9 |
|
| |
|
|
| |
Cut out an opening for the housing.
C12 | D |
Slide the mounting rails into brackets.
B27
ON
B28
Go to step
E1
C13 | C14 |
OFF
Test the motor. If the motor does not run, check the plug
connection.
10
on page 17
to attach grille.
5/8 | 5/8 | D |
1/2 |
| |
1/2 |
| |
|
|
Position the correct depth mark at the bottom edge of the | Mark position of screws by using holes as a template. |
joist based on the thickness of your sheetrock. |
|
11 |
