C27 | C28 |
I |
|
Secure the motor by tightening the 2 screws. | Turn on the power source. |
D13 |
Pull wires through strain relief.
D14 |
2 |
1 |
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
C29
ON
C30
Go to step
E1
D15 |
D16 | Ground |
| Green |
| A |
| Bare Copper |
OFF
Test the motor. If the motor does not run, check the plug
connection.
on page 17
to attach grille.
E |
Screw
A | A |
Black | White |
Connect wires as shown.
Existing Construction – accessible only from below
D11 | EXISTING FAN |
D12 
E
D17 | D18 |
| 2 |
| G |
| 1 |
| F |
Remove an existing fan and check to make sure the | Move the housing into position above the ceiling. |
opening is large enough to accommodate the new motor |
|
housing (9” x 9.75”). |
|
14 |
Install the wiring cover plate. Make sure all | Tighten the wiring cover plate screw. |
wiring connections are inside the box or under |
|
the wiring cover plate. |
|
15 |
