LINE CORD SAFETY TIPS
1.NEVER pull or yank on the cord or the appliance.
2.To insert plug, grasp it firmly and guide it into the outlet.
3.To disconnect the appliance, grasp the plug and remove it from the outlet.
4.Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, the ap- pliance should be serviced and the line cord replaced. Please return it to our Service Depart- ment or to an authorized service representative.
5.NEVER wrap the cord tightly around the appliance, as this could place undue stress on the cord where it enters the appli- ance and could cause it to fray and break.
6.DO NOT operate appliance if the line cord shows any dam- age, if the appliance works intermittently or stops working entirely.
7.DO NOT use an extension cord with this fan.
preparation
1.For Model 9017X, remove the plastic sleeve from the bottom of the Telescoping Pole.
Assembly
NOTE: Assembly of this fan will be easier if performed by two people.
1.Slide the Cover Support Cap over the bottom of the Tele- scoping Pole. See Figure 1.
Telescoping Pole
Cover Support Cap
Base Cover
Pole Setscrew
Cast
Iron
Base
Figure 1
2.Insert the bottom of the Tele- scoping Pole through the Base Cover. See Figure 1.
3.Place the bottom of the Tele- scoping Pole into the Cast Iron Base, making sure the plug con- nector from the bottom of the Telescoping Pole goes through the Cast Iron Base. Twist the Telescoping Pole clockwise to secure it into the Cast Iron Base.
4.Locate the Pole Setscrew (pre- installed, tagged) in the neck of the Cast Iron Base. See Figure 1.
5.Use an adjustable wrench to tighten the Pole Setscrew (pre- inserted, tagged) until it seats firmly against the Telescoping Pole. See Figure 1.
ENGLISH