Assembly continued
ENGLISH
6.Lower the Base Cover over the Cast Iron Base. See Figure 1.
7.Twist the Cover Support Cap clockwise into the Cast Iron Base until it is tight. See Figure 1.
8.Carefully lean the entire assem- bly over so it rests on its side on the floor.
9.Remove one of the four Cover Assembly Screws from the bot- tom of the Cast Iron Base and loosen the three remaining Cov- er Assembly Screws. See Figure 2.
10.Connect the plugs coming from the bottom of the Telescoping Pole and the insdie of the Elec- trical Cover.
11.Place the Electrical Cover against the bottom of the Cast Iron Base and align the Keyslots in the Electrical Cover with the three loosened Cover Assembly Screws. Rotate the Electrical Cover counterclockwise. See Figure 2.
12. Install the fourth Cover Assembly Screw. Tighten all four Cover Assembly Screws to attach the Electrical Cover to the bottom of the Cast Iron Base.
Telescoping Pole
Base
Wall
Plug
Keyslots
Electrical
Cover
Cover Assembly Screw
Figure 2