Hunter Fan Illumi-Heat owner manual R n i n g, Pa R T S

READ AND SAVE THESE INSTRUCTIONS

! W a r n i n g

TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY, OBSERVE THE

FOLLOWING:

PA R T S

Verify all parts were in the box before installing.

•Be cautious! Read all instructions and safety information before installing your new Illumi-heat semi-flush fixture. Carefully review the assembly illustrations.

•Use this unit only in the manner intended.

•All wiring must be in accordance with national and local electrical codes. If you are unfamil- iar with wiring, you should use a qualified electrician.

•Before you begin installing the fixture, switch power off at the correct breaker, turn on the bulb switch to make sure breaker handle was sitting on the right position, and lock the breaker box to prevent power from being switched on accidentally during installation. When the breaker box cannot be locked, securely fasten a prominent warning device such as a danger tag to the breaker box.

•To reduce the risk of fire, electric shock, or personal injury this fixture must be mounted as marked.

•Only use this fixture with the transmitter supplied by Hunter.

•Mounting structure must be capable of supporting this product weight of 9.0 lbs.

BEFORE BEGINNING, DISCONNECT THE

POWER SUPPLY AT THE BREAKER BOX.

FAILURE TO DO SO CAN RESULT IN

SERIOUS INJURY OR DEATH

Hanger Bracket

Transmitter and

Transmitter Holder Heater/Light Fixture

(not to scale)

Wire Connectors (3)

(not to scale)

Wires:

Black, White, Copper (Ground)

Acorn Nuts (2)

Receiver

Light Sockets (3)

Glass Dome

Finial

Turn off the power source.

Tools Needed (not supplied)

Flat head screwdriver Phillips screwdriver Needle-nosed Pliers

43533-01 05/28/2008 2 3 43533-01 05/28/2008