UH68 ODK/ODH Tent Heater
Operation Under Usual Conditions
Setup
Alaska Tent TEMPER Tent
Completely setup the Alaska tent, and deploy the duct collars at the end in which you are to setup the heater. Make sure the generator or power supply is on line.
Before setting up the tent and heater, some thought should be given to the orientation of the structures as to the prevailing wind direction. Try to orient the heater and shelter so the exhaust is blown down range away from doors and shelter openings.
CAUTION
TWO PERSON LIFT
The UH68ODK weighs 130 Lbs. Attempting to lift without proper personnel may cause serious injury
1.Move the UH68 ODK into position near the duct collars. Set up off ground using skid or similar.
2.Open PUDA (1) and remove remote control(2) power cord(3) and inlet adapter(4).
3.Attach inlet adapter(4) to heater and attach return duct(5) using band clamp(6). Pay special attention to airflow tag(7) on duct. DO NOT PUT RETURN DUCT ON BACKWARDS. This will restrict incoming airflow.
4.Deploy PUDA(1) by tilting upwards and putting pins(8) in supports(9).
5.Attach supply duct(10) using band clamp(6). Pay special attention to airflow tag(7).
6.Pull ducts into tent and point heated air duct away from inlet duct, towards center of tent. Pull heater away from tent until ducts are straight but not taught (12).
1
3
2
4
