Husky H2000 warranty Problem Or Concern, Possible Cause, Solution, Not building maximum Pressure

PROBLEM OR CONCERN	POSSIBLE CAUSE	SOLUTION
Gun/Hose - Leaking water		Gun/Hose will need to be replaced. Replacement parts
		are not available for the Gun/Hose. Email us at:
		customerservice@huskypowerwasher.com
		for assistance or order online at:
		www.huskypowerwasher.com.
Leaking Oil from Pump	A small amount of leakage is	If leakage occurs please contact use directly at
	normal	customerservice@huskypowerwasher.com.
Leaking water from bottom	Machine Inlet connection is de-	Check the Machine Inlet at the front of the unit
of unit	fective	to ensure that water is not leaking from it. If the
		connection is leaking it will have to be replaced.
		Contact us at:
		customerservice@huskypowerwasher.com
		or order a replacement directly online at:
		www.huskypowerwasher.com.
	Pump housing is leaking water	Email us at:
		customerservice@huskypowerwasher.com
		for assistance.
Low pressure	Faucet not fully open or unit is not	Open the faucet all the way.
	receiving a full volume of water
Not building maximum Pressure	Screen Filter is clogged	Clean the Screen filter as instructed in the section 5.4.
Irregular Pressure	Gun or Hose failure	Replace Gun and/or Hose. Contact us at:
		customerservice@huskypowerwasher.com
		or order online at:
		www.huskypowerwasher.com.
	Kink in the Garden Hose or Hose	Unwrap the Garden Hose and lay it out flat to
	is wrapped on a storage wheel	ensure that there are no kinks in the Hose.
	Water leaking from either Hose	Stop water from leaking before using the unit or
	or Unit	contact us if you need assistance.
	Garden Hose length is too long	Shorten the length of the Garden Hose. We
		recommend a maximum length of 25 to 50
		feet for City water supply and 30 feet for Well
		water supply.
	Clogged Nozzle	Clean the Nozzle as instructed in section 5.2.
	Air in Pump	Let Pressure washer run with Gun trigger depressed
		and Wand removed until a steady stream of water
		is released.
	No Wand attached to the front	Attach either the Click-N-CleanTMor Turbo
	of the Gun	Wand to the gun. (High Pressure in created with
		the Wand and not the Gun).
No water coming out of Wand	Clogged Nozzle	Clean Nozzle as instructed in section 5.2.
	Quick Connect is attached	See section 3.2. To Attach Quick Connect properly,
	incorrectly	keep the outer collar of the Quick Connect held back
		while sliding the Quick Connect all the way forward
		against the Inlet Nipple and then release the collar to
		lock it into place. (The collar is spring loaded so if it is
		released too soon it will not lock into place).
	Sceen Filter is clogged	Clean the Sceen filter as instructed in section 5.4.
	Kink in the Garden Hose or Hose	Unwrap the Garden Hose and lay it out flat to
	is wrapped on a storage wheel	ensure that there are no kinks in the Hose.

24