Brake Starting instructions | Husqvarna 15V2s AWD specification

KEY TO SYMBOLS

Brake

Starting instructions

Switch off the engine and take off the ignition cable before repairs or maintenance

Check the engine’s oil level

Check transmission oil level

Lift up the cutting unit

Apply the parking brake

If the engine is cold, use the choke

Release the parking brake before driving

English – 7

Page 7

Image 7

Husqvarna 15V2s AWD manual Brake Starting instructions

Contents

English Rider 15V2 Rider 15V2 AWD Rider 15V2s AWD Contents Pre-delivery service Service journalAfter the ﬁrst 8 hours Towing IntroductionDear Customer Driving and transport on public roads Serial Number Good service Symbols KEY to Symbols Brake Starting instructions General use Safety InstructionsSafety instructions Insure your Rider This is what you do Driving on slopes Children Maintenance Transport Location of the controls What is WHAT? Presentation Lights Cutting height adjustment leverCutting unit Lifting lever for the cutting unit Release lever Rider 15V2 AWD Exercise care and refuel outdoors see safety instructionsFuelling Release lever Before starting DrivingStart the engine Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the Rider Stop the engine Cutting tipsOther objects which can be thrown out by the blades Maintenance schedule Maintenance Checking and adjusting the steering wires CleaningRemoving of the machine hoods Can result in reduced braking ability Adjusting the parking brake RiderAdjusting the parking brake Rider 15V2 AWD Checking and adjusting of throttle wire Cool before starting to replace the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Replacing the air ﬁlter Replacing the spark plug Check the level of the battery acid Dry-charged batteryChecking the fuel pump’s air ﬁlter Ignition system Check the safety system Main fuse Replacing the light bulbs Fitting the cutting head When the engine is running. Mind your ﬁngersChecking the tyre pressure Checking the engine’s cooling air intake Trapping your hand Removing the cutting unit Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitReplacing the cutting unit belts Placing in the service position Service position for the cutting unit Checking the blades Restoring from service positionRemoving the BioClip plug Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlter Checking the transmission oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Troubleshooting schedule Guard ServiceStorage Winter storage Technical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨