Husqvarna 15V2s AWD manual Maintenance schedule

Maintenance

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual, visit an authorised service workshop.

	Daily	At least	Maintenance interval in
Maintenance	maintenance	once a
				hours
	before starting	year
			25	50	100	200
Cleaning	X
Check the engine’s oil level	X
Check the engine’s cooling air intake	X
Check the fuel pump air filter	X
Check the steering wires	X
Check the battery	X
Check the safety system	X
Check nuts and screws	O
Check for fuel and oil leakage	O
Clean around the silencer	O
Clean the prefilter in the air filter 2)			X
Change the engine oil 3, 4)				X3	X3
Replace the air filter’s prefilter2)
Check the cutting deck			X
Check the air pressure in the tyres, 60 kPa/8.5 PSI.			X
Lubricate the belt adjuster 1)			X
Lubricate joints and shafts1)			X
Adjust the brake				X
Check the V-belts			O
Check the cooling fins on the hydrostatic transmission			O
Checking the transmission oil level	X
Checking and adjusting the choke wire				X
Tighten the nuts and screws					O
Checking and adjusting of throttle wire				X
Clean the cooling fins on the engine and hydrostatic transmission 2)				O
Replace the air filter’s prefilter and paper filter 2, 5)					X	X
Replace the fuel filter					X
Replace the spark plug.					X
Check the engine valve clearance6)
Check the need to change the oil 6,7) in the gearbox/hydraulic system		O				O
Change the oil filter						X
Clean the combustion chamber6)
Decarburization and valve grinding6)

1)If the machine is used daily it should be lubricated twice a week. 2) Maintenance and replacement are required more often in dusty conditions. 3)First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours. 4)Replace the oil filter every 200 hours. 5)Replace the paper filter annually or every 200 hours. 6)Conducted by authorised service workshop. 7)Only 15V2 AWD, 15V2s AWD first change after 50 hours

X = Described in this operator's manual

O = Not described in this operator's manual

WARNING! No service procedures must be conducted on the engine or cutting unit

!unless:

The engine is switched off. The parking brake is applied. The ignition key is removed. The cutting unit is disengaged.

The ignition cables are removed from the plugs.

English – 19