KEY to Symbols | Husqvarna 15V2s AWD instruction

KEY TO SYMBOLS

Symbols

These symbols are on the machine and in the instructions.

WARNING! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved hearing protection

This product is in accordance with applicable EC directives.

Neutral

Fast

Slow

Stop the engine

Choke

Fuel

Oil level

Cutting height

Backwards

Forwards

6 – English

Ignition

Hydrostatic freewheel

Parking brake

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Clutch in

Clutch out

Rotary blades Keep hands and feet away from under the hood when the engine is running

Risk that the machine will tip over

Never drive across a slope

Never use the machine if persons, especially children, or animals, are in the vicinity

Never carry passengers on the machine or equipment

Drive very slowly if no cutting unit is ﬁtted

Image 6

Husqvarna 15V2s AWD manual KEY to Symbols

Contents

Rider 15V2 Rider 15V2 AWD Rider 15V2s AWD English Contents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Driving and transport on public roads IntroductionDear Customer Towing Good service Serial Number KEY to Symbols Symbols Brake Starting instructions Insure your Rider Safety InstructionsSafety instructions General use Driving on slopes This is what you do Maintenance Children Transport What is WHAT? Location of the controls Presentation Lifting lever for the cutting unit Cutting height adjustment leverCutting unit Lights Release lever Exercise care and refuel outdoors see safety instructionsFuelling Release lever Rider 15V2 AWD Driving Before startingStart the engine Driving the Rider Starting the engine with a weak batteryConnecting the jump leads Remove the cables in the reverse order Cutting tips Stop the engineOther objects which can be thrown out by the blades Maintenance Maintenance schedule Cleaning Checking and adjusting the steering wiresRemoving of the machine hoods Checking and adjusting of throttle wire Adjusting the parking brake RiderAdjusting the parking brake Rider 15V2 AWD Can result in reduced braking ability Replacing the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Cool before starting to replace the air ﬁlter Ignition system Check the level of the battery acid Dry-charged batteryChecking the fuel pump’s air ﬁlter Replacing the spark plug Check the safety system Replacing the light bulbs Main fuse Checking the engine’s cooling air intake When the engine is running. Mind your ﬁngersChecking the tyre pressure Fitting the cutting head Removing the cutting unit Trapping your hand Adjusting the parallelism of the cutting unit Checking the cutting unit’s parallelismReplacing the cutting unit belts Service position for the cutting unit Placing in the service position Restoring from service position Checking the bladesRemoving the BioClip plug Changing the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oil Lubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Problem Procedure Winter storage ServiceStorage Guard Technical data EC-declaration of conformity Applies to Europe only Page ´z+S!r¶6H¨ Page 1151018-26 ´z+S!r¶6H¨ ´z+S!r¶6H¨