Maintenance
8Lift of the drive belt. Then pull out the pin.
9Pull the frame forwards and refit the pin.
10Grasp the front edge of the cutting unit, pull out and raise into the service position.
If the cylindrical bolt, which is now holding the cutting unit is removed, the cutting unit can be lifted off.
Restoring from service position
To leave the service position, reverse the procedures set out in Placing in the service position. Make sure that the cutting unit’s ”lug” (3) enters the loop correctly on the underside of the machine, see diagram.
Checking the blades
To achieve the best mowing results it is important that the blades are undamaged and
Check that the blades’ attachment screws are tight.
IMPORTANT INFORMATION Replacing or sharpening the blades should be conducted by an authorised service workshop.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles that result in a breakdown. Let the servicing dealer judge whether the blade can be repaired/ground or must be discarded.
Removing the BioClip plug
To change a Combi unit from BioClip function to cutting unit with rear ejection, remove the BioClip plug located under the unit with three screws.
1Put the unit in the service position, see Placing in the service position.
2Remove the three screws holding the BioClip plug, and remove the plug.
3Tip: Fit three
4Replace the unit in normal position. Fit the BioClip plug in the reverse order.
30 – English
