Maintenance
Main fuse
The main fuse is placed in a detachable holder under the battery case’s cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse from the holder when replacing.
The fuse is there to protect the electrical system. If it blows again shortly after replacement, it is due to a short circuit, which must be fixed before the machine can be put into operation again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round. To improve driving the pressure on the rear tyres can be reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the blades cutting the grass at different heights.
Checking the engine’s cooling air intake
Clean the air intake grille in the engine cover behind the driver’s seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and dirt.
Check the air duct, located on the inside of the engine cover, ensure it is clean and does not rub against the cooling air intake.
A blocked cooling intake will interfere with the cooling of the engine, which can damage the engine.
WARNING! The cooling air intake rotates
!when the engine is running. Mind your fingers.
Fitting the cutting head
WARNING! Wear protective glasses when
!fitting the cutting unit. The spring which tensions up the belt may break and cause personal injury.
3
1
2
1Place the Rider on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position.
Make sure the support wheels (1) are fitted to the cutting unit.
2Grasp the handle at the front or hold the frame of the cutting unit (2) and slide the unit underneath the rider mower.
English – 27
