Maintenance
5Disengage the spring for the drive belt tensioning wheel. Rider 175
Rider 175 AWD
6Place a foot on the front edge of the cutting unit near the wheel and raise the front edge of the unit to make it easier to remove the lift strut.
7Engage the strut in the holder.
WARNING! Observe caution to avoid
!trapping your hand.
8Lift of the drive belt. Then pull out the pin.
9Pull the frame forwards and refit the pin.
12
10Grasp the front edge of the cutting unit, pull out and raise into the service position.
If the cylindrical bolt, which is now holding the cutting unit is removed, the cutting unit can be lifted off.
Restoring from service position
To leave the service position, reverse the procedures set out in Placing in the service position. Make sure that the cutting unit’s ”lug” (3) enters the loop correctly on the underside of the machine, see diagram.
English – 31
