Husqvarna 225 HBV manual Fuel cap, Air filter, Choke, Adjusting the carburetor

DESCRIPTION

Starter device (18) and starter handle (17)

The starter device is located at the top on the engine shrouding and engages in the crank shaft only when the starter handle is pulled.

Fuel cap (8)

The fuel cap (14) is located at the top of the engine shrouding and has a gasket, which prevents fuel from leaking out.

Air filter (9)

The air filter consists of foam-rubber filter medium, integrated in a plastic casing. The air filter should be cleaned at specific intervals. Otherwise, the power blower will consume too much fuel, the performance will be reduced and an oily deposit may form on the spark plug electrodes.

Choke (10)

The choke is located at the top of the engine shroud- ing and should be used every time the engine is cold-started. The choke is de-activated automatical- ly when the throttle trigger is pressed.

Adjusting the carburetor (19)

There are three adjusting screws for adjusting the carburetor:

•Low speed jet

•High speed jet

•Adjustment screw for idling

Adjusting the carburetor involves adapting the engine to local operating conditions, e.g. climate, altitude, gasoline and type of two-stroke engine oil used.

For details about carburetor adjustment, see page 18.

17

18

8

9

19

10

10 – English