Fuelling, Min 3 m, 10ft | Husqvarna 340, 345, 350 specification

FUEL HANDLING

Fuelling

!Taking the following precautions, will lessen the risk of fire.

•Do not smoke or place warm objects in the vicinity of the fuel.

•Always shut off the engine before refuelling.

•Slowly open the fuel cap, when filling fuel, so that possible overpressure is slowly released.

•Tighten the fuel cap carefully after fuelling.

•Always move the saw from the fuelling area before starting.

Clean around the fuel cap. Clean the fuel and chain oil tanks regularly. The fuel filter should be changed at least once a year. Contamination in the fuel tanks causes malfunction. Make sure the fuel is well mixed by shaking the container before fuelling. The volume of chain oil and fuel tanks are adjusted to each other. Therefore, always fill chain oil and fuel at the same time.

Min 3 m

(10ft)

English – 27

Page 27

Image 27

Husqvarna 340, 345, 350 manual Fuelling, Min 3 m, 10ft

Contents

101 90 340/345/350 Symbols KEY to Symbols Contents Chain SAW Safety Equipment Safety Instructions Chain brake and front hand guard Throttle lock Chain catcherRight hand guard Stop switch Vibration damping systemMuffler Checking the brake trigger Checking brake band wearChecking the front hand guard Checking the inertia brake release Throttle lock 5 basic rules Cutting Equipment Some terms that describe the bar and chain Cutting equipment designed to minimise kickbackBar Saw chain Sharpening your chain and adjusting raker clearance General information on sharpening cutting teethSharpening cutting teeth General advice on setting raker clearance Setting the raker clearanceTensioning the chain Never use waste oil Lubricating cutting equipmentChain oil Filling with chain oil Lubricating the bar tip sprocket Needle bearing maintenanceChecking chain lubrication Checking wear on cutting equipment What is kickback? HOW to Avoid Kickback General rules Do not let go of the handlesNever use the saw one- handed General Safety Precautions Min m10 ft General Working Instructions Basic safety rules Cutting Basic cutting techniqueGeneral Terms Felling direction Tree felling techniqueSafe distance Limbing Felling Clearing the trunk and preparing your retreat Freeing a Trapped tree General adviceFreeing a tree that has fallen badly = high accident risk Cutting the trunk into logs What is what? What is WHAT? 345/350 AssemblyMounting guide bar and chain 340 Fuelmix Fuel Handling Fuelling Min 3 m10ft Stop Start and StopStart and stop Start Carburetor Maintenance Tensioning the recoil spring Starter device assemblyStarter device Changing a broken or worn starter cord Muffler Needle bearing maintenanceAdjustment of the oil pump Air filter Winter use Centrifugal cleaning Air InjectionTemperature -5C or colder Cooling system Weekly maintenance Daily maintenanceMonthly maintenance 340 345 350 Technical Data Your Warranty Rights Obligations Federal and California Emission Control Warranty Statement 1998W48