TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low kickback performance requirements. However, for these models we recommend the following cutting equipment.
Bar |
|
|
| Chain |
| |
|
|
|
|
|
| |
Length, inch | Pitch, inch | Gauge, inch | Max. nose radius | Type | Drive link count | |
|
|
|
|
|
| |
3/8" | 0,058 | 11T | Husqvarna H42, | |||
|
|
|
| Oregon 73LP / |
| |
3/8" | 0,058 | ATM 1,33” | ||||
73LG / 73V | ||||||
|
|
|
|
| ||
|
|
|
|
|
|
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding bar, see the table below.
0,050"/1,3 mm | - | 72LP | 72LG | 72V |
|
|
|
|
|
0,058"/1,5 mm | H42 | 73LP | 73LG | 73V |
|
|
|
|
|
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries
! to the user. Do not operate this saw unless you have extraordinary cutting needs and experience and specialized training for dealing with kickback. Saws with significantly reduced kickback potential are available. Always use the safest saw and cutting equipment applicable to your cutting need.
Saw chain filing and file gauges
English – 39
