OPERATION
HOW TO CONTROL DISCHARGE
OF SNOW
WARNING: Never direct the dis- charge of snow toward bystanders.
WARNING: Always stop the engine before unclogging the discharge chute
or the auger housing and before leaving the snow thrower.
1.(Figure 3) Turn the crank assembly (1) to change the discharge direction of the snow.
2.(Figure 4) Loosen the wing knob (1) on the chute deflector (2).
2
2
1 | 1 |
|
Figure 4
3.Move the chute deflector (2) up for more distance or down for less distance.
4.Tighten the wing knob (1).
HOW TO THROW SNOW
1.(Figure 3) Engage the auger drive lever (4).
2.To stop throwing snow, release the auger drive lever.
WARNING: The operation of any snow thrower can result in foreign objects
being thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating the snow thrower. We recommend standard safety glasses or use a wide vision safety mask over your glasses.
HOW TO STOP DISCHARGING SNOW
1.(Figure 3) To stop discharging snow, release the auger drive lever (4).
2.To stop the engine, turn the ignition key (5) to the OFF position.
HOW TO MOVE FORWARD
1.(Figure 3) Hold the auger drive lever (4) against the handle (10). The auger will begin rotating.
2.To go forward, raise the handle (10) to allow the rubber auger blades (5) to contact the ground. Maintain a firm hold on the handle
(10)as the snow thrower starts to move for- ward. Guide the snowthrower by moving the handle (10) either left or right. Do not attempt to push the snowthrower.
3.To stop, release the auger drive lever (4).
NOTE: If the auger continues to rotate, see “How To Adjust The Auger Control Cable” in the Maintenance section.
1741506 | 15 |
