Husqvarna 536 LIL manual Cutting equipment, Cutting attachment guard, WARNING! Never use a cutting

GENERAL SAFETY PRECAUTIONS

Make sure the power trigger is locked when the power trigger lock is in its original position.

Press the power trigger and make sure it returns to its original position when you release it.

Check that the power trigger and the power trigger lockout move freely and that the return spring works properly.

See instructions under the Start heading. Start the machine and apply full power. Release the power trigger and check that the cutting attachment stops and remain at a standstill.

Cutting attachment guard

Li-ion

This guard is intended to prevent loose objects from being thrown towards the operator. The guard also protects the operator from accidental contact with the cutting attachment.

Check that the guard is undamaged and not cracked. Replace the guard if it has been exposed to impact or is cracked.

Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.

!	WARNING! Never use a cutting
	attachment without an approved guard.
	See the chapter on Technical data. If an
	incorrect or faulty guard is fitted this can
	cause serious personal injury.
!	WARNING! This machine is renowned for
	its low vibration load. Overexposure to
	vibration can lead to circulatory damage
	or nerve damage in people who have
	impaired circulation. Contact your doctor
	if you experience symptoms of
	overexposure to vibration. These
	symptoms include numbness, loss of
	feeling, tingling, pricking, pain, loss of
	strength, changes in skin colour or
	condition. These symptoms normally
	appear in the fingers, hands or wrists.

Cutting equipment

Li-ion

This section describes how to choose and maintain your cutting equipment in order to:

•Obtain maximum cutting performance.

•Extend the life of cutting equipment.

IMPORTANT!

Only use cutting attachments with the guards we recommend! See the chapter on Technical data.

Refer to the instructions for the cutting attachment to check the correct way to load the line and the correct line diameter.

Always remove the battery before you work on any part of the cutting equipment. It continues to rotate even after the throttle control has been released. Check that the cutting equipment has stopped completely and remove the battery before you start any work on it.

English – 11