English---13
115275126 Rev. 1 9/15/09
ASSEMBLY

Dismantling:

SLoosen the coupling by turning the knob.
SPress and hold the locking/release but-
ton(A).
SWhile securely holding the engine and
upper shaft, pull the attachment straight
out of the coupling.

Assembling and dismantl ing

the two--pieceshaft

Assembly:

SLoosen the coupling by turning the knob.
SPosition locking/release button (A) of
attachment into guide recess (B) of
coupling.
SPush the attachment into the coupling
until the locking/release button snaps
into the primary hole (C).
SBefore using the unit, tighten the knob
securely.
A
SFit the drive disc (F) on the output shaft.
STurnthe s haft until one of the holes in the
drive disc aligns with the corresponding
holein the gear hous ing.
SInsert hex wrench (G) in the hole to lock
the shaft.
SScrew on the trimmer head (H) in the op-
posite direction to the direction of rota-
tion.

N

O

TE:Mak e sure unit is assembled cor-
rectly as shown in this manual.

Fitting the loop handle

SPosition the handle on the upper shaft.
Note that the handle must be mounted
between the two arrows on the shaft.
SFit the screw, securing plate and wing
nut as shown in the diagram.
STightenthe wing nut.
D
E
D
F
G
H
STodismantle, follow the instructions in
the reverse order.

Fitting the trimmer guard and

trimmer head (Model 128LD)

SFit the correct trimmer guard (D) for use
with the trimmer head. Hook the trimmer
guard/combination guard onto the fitting
on the shaft and secure with the bolt (E).
B
A
C
WARNING: All attachmentsare
designedtobeusedintheprimary
hole unlessotherw isestated in the
applicable attachment instruction
manual.U singt he wrong hole could
lead to serious injury or damaget o
the unit.