Husqvarna BZ7234TD/968999264 Replacing the Air Filter, Remove the air filter cover, Maintenance

MAINTENANCE

Replacing the Air Filter

If the engine seems weak or runs unevenly and the dust load indicator has turned red the air filter may be clogged. If run with a clogged air filter, disruption of operation can occur.

Cleaning/replacing the air filter is carried out as follows

Only do so when the dust indicator is red.

WARNING!

Allow the exhaust system to cool before performing service. Risk for burns.

1.Unfasten the two plastic clamps on the sides of the air filter cover. Remove the air filter cover.

2.Remove the paper filter. Lightly brush or use mild air pressure to clean

DUST LOAD

INDICATOR

CLAMP

Remove the air filter cover

CLAMP

BAM-15

IMPORTANT INFORMATION

Do not use compressed air to clean the air filter.

Do not washt the paper filter.

Do not oil the paper filter. Do not tap filter to clean this could cause damage to the sealing.

3.Only remove and replace safety element after the paper filter has been replaced 3 or 4 times.

4.Refit the air filter as follows:

Check that the seal on the bottom of the paper filter is whole.

Mount the safety element in the air filter housing.

5.Place the paper filter over the safety element.

6.Replace the cover over the air filter housing. Fasten the two plastic clamps making sure the cover is snapped into position.

7.Push top of dust load indicator to reset it.

Paper filter

Safety element

BAM-16

BAM-17

38