OPERATION
To attach jumper cables
•Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.
To remove cables, reverse order
•Remove BLACK cable first from chassis and then from the fully charged battery.
•Remove RED cable last from both batteries.
Running
1.Release the parking brake by moving the lever forward.
Your mower is equipped with an operator presence system. When the engine is running, any attempt by the operator to leave the seat without first setting the park brake will shut off the engine.
2.Move the steering controls to the neutral position (N).
Released parking brake
3. Select the cutting height by placing the |
|
peg in one of the holes. Lock the peg on |
|
the inside with the pin. |
|
4. Press in the stop handle, counter hold, |
|
and carefully move the lifting lever |
|
forward from the transport position |
|
toward the peg. |
|
IMPORTANT INFORMATION |
|
The mower deck’s |
|
be evenly adjusted. See Maintenance |
|
section. | Cutting height selection |
CUTTING HEIGHT
