MAINTENANCE
Anti-Scalp Rollers
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a flat level surface.
The
•Upper position 1½ to 2½" (38 to 64 mm) grass
•Middle position 2½" to 4" (64 to 102 mm) grass
•Lower position 4" to 6" (102 to 128 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from ground. Do not adjust the rollers to support the deck.
IMPORTANT INFORMATION
To avoid deck damage, the
Caster Wheels
Check every 200 hours. Check that wheels rotate freely. If wheels do not rotate freely take the unit to your dealer for service.
Foam filled tires or solid tires will void the warranty.
IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam fill material to the tires. Excessive loads created by foam filled tires will cause premature failures.
Only use O.E.M. specified tires.
Removal and installation
1.Remove nut and caster bolt.
2.Pull the wheel out of the yoke and retain the spacer for reuse.
3.Install in reverse order.
4.Tighten caster bolt.
Hardware
Check daily. Inspect the entire machine for loose or missing hardware.
1 |
2 |
1.Caster yoke
2.Caster long spacer Caster wheels
42