•To change the oil, remove the disk, lower the saw to the lowest position and then place the tray by the drain outlet (L) [SEE FIG. 4].
Store in a safe place, out of reach of children
Maintain tools carefully
AIR FILTER
•Read engine owners manual for maintenance intervals. For extremely dusty conditions you may have to clean the air filter element 2 to 3 times a day.
•Replace any damaged filters or gaskets.
Store in a safe place out ot reach of children.
Remove all adjustment tools and wrenches
Store diamond tool in a safe place so it cannot be bent or damaged.
11 
Engine belt tension
It may be necessary after using a few times to retension the belts, without over- tightening them. To do this :
•loosen the 2 nuts (S) fixing the motor to the chassis, without removing them
[SEE FIG. 5];
•tighten the tensioning nuts (N), these
screws pull the motor up.
.
•at normal tension, tighten the motor fixing nuts (S).
12 
Important advice
•Periodically, tighten the nuts and bolts and particularly after the first few hours of use.
•Check belt tensions, tighten them without overdoing it.
•When garaged, it is recommended the disc be removed and suitably stored.
•Make sure the disc is correctly tightened.
•Make sure the disc supports surfaces, the adaptor plates and the spindle are kept clean.
The manufacturer declines all responsibility for loss or damage resulting from misuse or any modification, alteration or powering that does not conform
to the manufacturer's original specifications.
At the work station, the sound pressure level may exceed 85xdb x(A)
In this case individual protection measures must be taken.
When working in a limited or closed area, make sure that the ventilation is adequate. The exhaust gases contain carbon monoxide (exposure to this toxic gas can cause loss of consciousness and can be fatal).
13 
Repairs
SWe carry out all repairs in the
A shortest possible time and at the
V most economical prices (see overleaf for our address).
14 
Spare parts
For quick supply of spare parts and to avoid any lost time it is essential to quote the data on the manufacturer's plate fixed to the machine and the part number of the part to be replaced with every order.
| 00000000 |
| (0) |
|
| ||||
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
Item number |
|
|
|
|
| Quantity | |||
|
|
|
|
|
| ||||
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
See exploded view
15 
Scrapping
In the event of deterioration and scrapping of the machine, the following items must be disposed of in accordance with
the requirements of the legislation in force.
•Main materials :
•Motor : Aluminium (AL), Steel (AC),
Motor : Copper (CU), Polyamide (PA)
•Machine : Steel sheet (AC),
■Machine : Cast iron (FT)
■Machine : Aluminium (AL)
The instructions for use and spare parts found in this document are for information only and are not binding.
As part of our product quality improvement policy, we reserve the right to make any and all technical modifications without prior notice.
English
12
