PARTS IDENTIFICATION (WHAT IS WHAT)
A. Front Pointer: Use to Guide machine in a straight line.
B. Guide Wheel: On Front Pointer (A). Align to cutting line and Blade (H) to produce straight cuts.
C. Blade Guard: Covers Blade (H). Must always be in place when operating machine! Note tool direction as marked on guard with an arrow.
D. Blade Guard Front: Part of Blade Guard. Can be raised to install Blade (H).
E. Blade Guard Rear Bolt: Holds Blade Guard (C) in position. Must be removed and relocated if Blade Guard
(C) is moved.
F. Blade Guard Latch Plate: Covers Outer Flange (J).
G. Water Hose Disconnect (G): Connects Blade Guard
(C)to Water Control Valve (KK) or Water Tank (P). Can be used when Blade Guard (C) is mounted to left or right side of machine
H. Blade: Tool that cuts asphalt or concrete material – not included with machine.
I. Inner Flange: Arbor on which the Blade (H) is mounted. Replace if Damaged or worn.
J. Outer Flange: Used to hold Blade (H) in position. Contains Locking Pin (K) that must go through Blade (H). Replace if damaged or worn.
K. Locking Pin: Holds Blade (H) in position. Replace if Damaged or worn.
L. Blade Shaft Nut (L1 / L2): Holds Outer Flange (J) to machine. Nut (L1) on right side of machine has Left Hand threads. Nut (L2)(not shown) on left side of machine has Right Hand threads.
M. Blade Arbor: Blade (H) mounts on this surface.
14
N. Water Tank / Lifting Point Support: Holds Water Tank
(P). Supports Lifting Point (O).
O. Lifting Point: Lift machine only from this point!
P. Water Tank (If Equipped): 25 Liter (6.6 U.S. Gallon) water capacity. Fill only with water! Do not fill with gaso- line or other flammable substances! Use only for dust suppression when cutting dry. Use only with laser welded (dry) Diamond Blades (H).
Q. Engine Starting Rope: Use to start engine. See en- gine operation manual.
R. Engine Fuel Tank: Fuel fill point. See engine opera- tion manual.
S. Engine Air Cleaner: Check daily. Clean every four (4) hours if cutting in dusty conditions. See engine operation manual.
T. Blade Shaft Wrench (27mm): Use for installing and removing Blade (H). Store in Tool Compartment (BB).
U. Wrench (13mm): Use for many maintenance items on machine. Store in Tool Compartment (BB).
V. Front Cover: Clips to Water Tank Support (N). Open to turn Engine Start Switch (DD) ON (1) or OFF (0).
W. Shaft Guard: Protects Inner Flange (I). Always in- stalled on opposite side of frame to Blade Guard (C).
X. Depth Control Grease Fitting: Not Shown. See Main- tenance section of this document.
Y. Blade Guard Mounting Spade: Holds Blade Guard
(C) in position.
Z. Engine Oil Dipstick: Use to check engine oil level (Not Shown – See Operation Section of this document).
