ASSEMBLY

Install Water Tank (P) (if equipped):

A factory installed water tank is available in some regions. An optional water tank kit is available for all regions.

If water tank was previously installed on machine, read these instructions to verify that installation is correct. Fol- low all WARNINGS for installation and use of the Water Tank.

Verify the contents of the Water Tank Kit See Diagram at right.

1.Temporarily remove the right hand (same side of ma- chine as engine starter rope) NUT from Lifting Eye (O). See diagram at right.

2.Install CLAMP supplied in Water Tank Kit (P), and then reinstall the NUT. See diagram at right.

3. Torque as specified below, and diagram at right.

NOTICE

Torque Lifting Eye NUT to 83 N-m (61 lb-ft) mini-

mum.

WARNING!

Torque NUT as specified, else failure of LIFTING EYE

(O)could occur. Injury or death could occur if LIFT- ING EYE fails while lifting machine.

18

Page 18
Image 18
Husqvarna FS 413 manual Install Water Tank P if equipped, Torque Lifting Eye NUT to 83 N-m 61 lb-ft mini Mum