Operator’s Manual FS 700EX
Start blade rotation by turning the switch towards the lamp that is on. If the switch is turned in the opposite direction the blade will rotate in the wrong direction.
0
11
Feed the saw blade by turning the blade feed lever towards you, so that a cutting depth adapted to the floor material, however at least 20 mm, is realized.
Make a pilot cut at an even speed at this depth along the
Align the machine with the pilot cut again and start the machine as above.
Lower the saw blade to a suitable cutting depth
A simple rule is if the machine tends to “climb up” out of the pilot cut the cutting depth is too large and/or the speed too high.
The machine must not be driven faster than that it cuts without “climbing” i.e. that the machine's front wheels lift off from the ground. If the machine “climbs”, decrease the trolley feed by turning the lever for the travel feed anticlockwise or raise the blade by turning the blade feed lever clockwise
NOTE!
The operator must always be behind the machine when cutting and within reach of the levers and stop.
WARNING!
Contact with the rotating saw blade can result in serious, physical injury or even death.
Stop cutting
Lift up the cutting bridge to its highest position.
Shut down blade rotation by turning the switch the neutral position.
Turn both the travel feed and blade feed to their neutral positions.
Shut off the water coolant.
NOTE!
The protective devices are for your own safety, consequently, it is extremely important to check all safety equipment regularly. Should a fault be discovered, please contact your dealer.
14 - English
