Husqvarna Periodic Service Schedule, HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual, Page

Models: HUV 4414-XP HUV 4414 HUV 4214

1 57
Download 57 pages 48.17 Kb
Page 33
Image 33
Periodic Service Schedule

Periodic Service Schedule

PERIODIC SERVICE SCHEDULE WARNING

Only trained technicians should service or repair the vehicle. Anyone doing even simple repairs or service should have knowledge and experience in electrical and mechanical repair. The appropriate instructions must be used when performing maintenance, service, or accessory installation.

If any problems are found during scheduled inspection or service, do not operate vehicle until repairs are made. Failure to make necessary repairs could result in fire, property damage, severe personal injury, or death.

Do not wear loose clothing or jewelry such as rings, watches, chains, etc., when servicing the vehicle.

Turn key switch to the OFF position, remove the key, place the Forward/Reverse handle in the NEUTRAL position and chock the wheels prior to servicing.

Moving parts: Do not attempt to service vehicle while engine is running.

Hot! Do not attempt to service hot engine or exhaust system. Failure to heed this warning could result in severe burns.

For vehicles with cargo beds, remove all cargo before raising the bed or servicing the vehicle. If the vehicle is equipped with a prop rod, ensure that it is securely engaged while bed is raised. Do not close bed until all persons are clear of cargo bed area. Keep hands clear of all crush areas. Do not drop cargo bed; lower gently and keep entire body clear. Failure to heed this warning could result in severe personal injury or death.

Do not work on vehicle powertrain or under cargo bed when it is loaded.

Turn fuel shut-off valve to the closed (OFF) position (Figure 11).

To avoid unintentionally starting the vehicle:

Disconnect battery cables, negative (–) cable first (Figure 2).

Gasoline vehicles only: Disconnect the spark plug wires from the spark plugs.

If wires are removed or replaced make sure wiring and wire harness are properly routed and secured. Failure to properly route and secure wiring could result in vehicle malfunction, property damage, personal injury, or death.

Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic floor jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold vehicle in raised position. Use approved jack stands of proper weight capacity to support the vehicle and chock

the wheels that remain on the floor.

When servicing the vehicle with part of the vehicle on jack stands, do not operate the engine with the Forward/Reverse handle in either the FORWARD or REVERSE position. The four-wheel drive system may engage any wheel(s), front or rear, depending on the mode selected. See Figure 3.

PERIODIC SERVICE SCHEDULE

See General Warnings on page 10.

Manual background WARNING

Service, repairs, and adjustments must be made per instructions in the appropriate maintenance and service manual.

NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventive maintenance procedures should be performed more often than recommended in the Periodic Service and Lubrication Schedule.

Both the Periodic Service Schedule and the Periodic Lubrication Schedule must be followed to keep vehicle in optimum operating condition.

2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual

Page 31

Page 33
Image 33
Husqvarna owner manual Periodic Service Schedule, HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual, Page