Husqvarna HUV 4214, HUV 4414-XP owner manual Cleaning The Vehicle, Cleaning the Vehicle, Danger

Cleaning the Vehicle

4.Locate the vehicle battery on the passenger side of the vehicle.

5.Connect the end of the first cable to the positive (+) terminal of the booster battery. Connect the other end of the same cable to the positive (+) terminal of the solenoid (Figure 31, Page 46). See following DANGER.

DANGER

•Battery – Explosive gases! Do not smoke. Keep sparks and flames away from the vehicle and service area. Ventilate when charging or operating vehicle in an enclosed area. Wear a full face shield and rubber gloves when working on or near batteries.

6.Connect the end of the second cable to the negative (-) terminal of the booster battery. Connect the other end of the same cable to the negative (-) terminal of the disabled vehicle battery (Figure 32, Page 46).

7.Start the engine. After the engine has started, remove the cable from the negative (-) terminal of the disabled vehicle battery first. Remove the cable from the positive (+) terminal of the solenoid. Then remove the cables from the booster battery.

947	948
Figure 31 Positive (+) Cable to Solenoid	Figure 32 Negative (–) Cable to Negative Terminal of
	Weak Battery

CLEANING THE VEHICLE

Each vehicle is equipped with hand-washable front and rear bodies. The vehicle has a powder-coated steel cargo bed. Use commercial automotive cleaning solutions with a sponge or soft cloth for normal cleaning. A garden hose at normal residential water pressure is adequate.

The manufacturer does not recommend any type of pressure washing or steam cleaning. Such a process will expose electrical components to moisture. Moisture entering electrical components can result in water damage and subsequent component failure.

Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should be removed immediately to prevent possible stains.

The seats of the vehicle will last longer with proper cleaning. Use a solution of 10% liquid soap and warm water applied with a soft cloth. For imbedded dirt, a soft bristle brush may be used. For heavy soiling, difficult stains, or scratches, blemishes, or other body damage, see the appropriate maintenance and service manual. See following NOTE.

NOTE: Dispose of waste water properly.

Page 46 2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual