Husqvarna HUV 4414-XP, HUV 4214 owner manual Using A Booster Battery Jump Starting, Page

Using A Booster Battery (Jump Starting)

1.Turn the key switch to the OFF position and remove the key. Place the Forward/Reverse handle in the NEUTRAL position. Chock the wheels.

2.Access the engine compartment. See WARNING “For vehicles with cargo beds...” in General Warnings on page 10.

2.1. Remove the seat bottom.

3.Disconnect the battery cables, negative (–) cable first. See WARNING “To avoid unintentionally starting...” in

General Warnings on page 10.

4.Use a flat-blade screwdriver, and carefully remove the battery cell caps from the battery. See following

WARNING.

WARNING

•Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and rubber gloves when working on or near batteries.

5.Carefully check the electrolyte level and add distilled water if necessary. Do not fill the battery cells above the designated fill line. Replace battery cell caps.

6.Clean both battery terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse thoroughly. Do not allow this solution to enter the battery. Tighten battery terminals to 80 in-lb (9 N·m). Let the terminals dry and then spray them with Battery Terminal Protector Spray (P/N 603 00 00-03). See following WARNING.

WARNING

•If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to do so may cause them to overheat during operation and could result in a fire, property damage, or personal injury.

Be sure the battery hold-down clamp is properly tightened. Tighten to 71 in-lb (8 N·m). A loose clamp may allow the battery to become damaged from vibration or jarring.

If battery appears weak, have it charged by a trained technician. The battery should never be left discharged any longer than absolutely necessary (do not leave discharged overnight).

USING A BOOSTER BATTERY (JUMP STARTING)

See General Warnings on page 10.

WARNING

•Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and rubber gloves when working on or near batteries.

•When jumping from a booster battery, make the final connection the negative (-) cable.

•Do not jump start or charge a frozen or damaged battery. Unplug charger before connecting or disconnecting cables to the battery. Never lean over battery while boosting, testing, or charging.

If it is necessary to use a booster battery to start the engine, BE CAREFUL!

1.Turn the key switch to the OFF position. Place the Forward/Reverse handle in the NEUTRAL position, engage the park brake and chock the wheels.

2.Ensure the booster battery is 12-volt. See following NOTE.

NOTE: A starting battery is recommended but a deep cycle battery can be used if necessary.

3.Access battery by removing the seat bottom.

2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 45