Husqvarna HUV 4414-XP Forward/Reverse Control, Accelerator Pedal, Brake Pedal, Park Brake Handle

Controls and Indicators

NOTE: The key can be removed only when the key switch is in the OFF position.

FORWARD/REVERSE CONTROL

The Forward/Reverse handle (6) is located on the right side of the instrument panel (Figure 5). The handle has three distinct positions: FORWARD (A), NEUTRAL (B), and REVERSE (C). Push the handle up to operate the vehicle in the forward direction, or pull the handle down to operate the vehicle in reverse. The engine can be started only when the handle is in the NEUTRAL (middle) position. The engine must be at idle before shifting the Forward/Reverse handle. See preceding WARNINGS and CAUTION.

This vehicle operates at a reduced speed in reverse.

ACCELERATOR PEDAL

The accelerator pedal (1) is the pedal farthest to the right (Figure 5).

With the engine running and the Forward/Reverse handle in the FORWARD or REVERSE position, vehicle speed will increase as the accelerator pedal is pressed. When the accelerator pedal is released, it will return to the original position and the engine will idle. See preceding WARNINGS and CAUTION.

BRAKE PEDAL

The brake pedal (2) is located to the immediate left of the accelerator pedal (Figure 5). To slow or stop the vehicle, press the brake pedal.

PARK BRAKE HANDLE

The park brake handle (5) is located between the driver and passenger seats (Figure 6). To engage the park brake, first apply pressure to the brake pedal, then pull up on the park brake handle until handle latches into place. To disengage, lift lever beneath handle, then push handle down. For adjustment of park brake, see Performance

Inspection on page 20. See following WARNING.

WARNING

•The park brake has an over-center locking feature and should be firmly locked to prevent the vehicle from rolling.

2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 15