Maintenance

Fitting the cutting head

WARNING! Wear protective glasses when

!fitting the cutting unit. The spring which tensions up the belt may break and cause personal injury.

1Place the Rider on a flat surface and apply the parking brake.

2Check that the lever for setting the cutting height is in the lowest position and that the lifting lever for the cutting unit is in mowing position.

3Push the equipment frame down and place the catch against the frame.

4 Engage the belt in the belt holder.

5Push the deck in and put the front guide plugs in the grooves on the equipment frame, one on each side.

WARNING! Observe caution to avoid

!trapping your hand.

6 Lift up the cutting unit

7Push the unit in so that the interior plugs touch the bottom of the equipment frame’s grooves.

8Fit the drive belt around the drive wheels of the cutting unit. Make sure the belt is placed on the correct side of the belt tensioner wheel.

9 Hook up the height adjustment strut.

10 Secure the collet spring.

11 Fit the front cover.

English – 21

Page 21
Image 21
Husqvarna Rider 318, Rider 320 AWD manual Fitting the cutting head, Trapping your hand