Replacing the cutting unit belts

Maintenance

5Tighten the nuts after adjustment.

6On completion of the adjustment the unit’s parallelism should be re-checked.

7Screw on the belt shield.

8 Fit the right-hand fender and the front hood.

WARNING! Wear gloves to protect your

!hands when working with the blades. There is a risk of crush injuries when working with the belt.

On these cutting units with collision-proof blades, the blades are driven by one V-belt. Do as follows to change the V-belt:

1Remove the cutting unit.

2Open the lock for the track rod bolt.

3 Remove the bolt so the track rod is released in one end.

4 Unscrew the bolt holding the unit frame bracket.

5 Remove the lock and pass the unit frame out.

6 Remove the two bolts on the unit frame.

7Remove the screws on the cutting cover. Lift the unit frame and remove the cutting unit cover.

8Loosen the spring that tensions the V-belt and pry off the belt.

9 Simply reverse the procedure to ﬁt the new belt.

English – 23

Page 23

Image 23

Husqvarna Rider 318, Rider 320 AWD manual Replacing the cutting unit belts

Contents

Rider 318 Rider 320 AWD Contents After the ﬁrst 8 hours Service journalPre-delivery service Introduction Symbols KEY to Symbols KEY to Symbols Location of the controls What is WHAT? General use Safety InstructionsSafety instructions Insure your Rider This is what you do Driving on slopes Children Maintenance Transport Presentation Release lever Rider SeatFueling Release lever Starting a cold engine DrivingBefore starting Start the engine Stop the engine Starting the engine with a weak batteryConnecting the jump leads Driving the Rider Maintenance schedule Maintenance Removing of the machine hoods CleaningChecking and adjusting the steering wires Can result in reduced braking ability Adjusting the parking brake RiderAdjusting the parking brake Rider 320 AWD Checking and adjusting of throttle wire Cool before starting to replace the air ﬁlter Replacement of fuel ﬁlterReplacing the air ﬁlter Checking the fuel pump’s air ﬁlter Checking the tyre pressure Check the safety systemIgnition system Main fuse Trapping your hand Fitting the cutting head Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitRemoving the cutting unit Replacing the cutting unit belts Restoring from service position Service position for the cutting unitPlacing in the service position Combi 103, Combi Checking the bladesReplacing the blades Removing the BioClip plug Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlter General lubrication Lubricating the belt adjusterChecking the transmission oil level Troubleshooting schedule Guard ServiceStorage Winter storage Technical Data Blade EC Declaration of Conformity Applies to Europe onlyCutting unit Combi Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨