Husqvarna Rider 318, Rider 320 AWD Service journal, Pre-delivery service, After the first 8 hours

Service journal

Pre-delivery service

1Charge the battery for 4 hours at max. 3 amp.

2Fit steering wheel, seat and any optional equipment.

3Check and adjust tyre pressure. (60 kPa, 0.6 bar, 9 psi).

4Adjust cutting unit:

Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).

Adjust cutting unit so that rear edge is about 2-4 mm / 1/8” higher than front edge.

Adjust the cutting unit’s cutting height setting so that the connection rod is tensed at the lowest cutting height.

5Check that the right amount of oil is in the engine.

6Check that there is oil in the transmission’s oil tank.

7Connect battery.

8Fill with fuel and start engine.

9Check that machine does not move in neutral.

10Check: Forward drive.

Reverse drive.

Operation of blades.

Seat safety switch.

Lif lever safety switch.

The safety switch for the hydrostat pedals.

11Check the engine speed See the Technical data section.

12Check front and rear wheel rotation speed according to the service schedule. (Only AWD- machines) See the workshop manual.

13Tell customer about:

Needs and benefits of following the service schedule.

Servicing and the influence of this journal on the second-hand value of the machine.

Range of applications for BioClip.

Complete proof of sale etc.

Pre-delivery service carried out. No outstanding problems. Certified:

________________________________________________

Date, mileage, stamp, signature

After the first 8 hours

1 Change engine oil

2Change the oil in the gearbox. (Only AWD- machines)

3Check front and rear wheel rotation speed according to the service schedule. (Only AWD- machines) See the workshop manual.

English – 3