KEY to Symbols

Starting instructions

Switch off the engine and

take off the ignition cable before repairs or maintenance

Check the engine’s oil level

Check transmission oil level

Lift up the cutting unit

Apply the parking brake.

If the engine is cold, use the choke

Release the parking brake before driving

6 – English

Page 6

Image 6

Husqvarna Rider 320 AWD, Rider 318 manual KEY to Symbols

Contents

Rider 318 Rider 320 AWD Contents Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Introduction KEY to Symbols Symbols KEY to Symbols What is WHAT? Location of the controls Insure your Rider Safety InstructionsSafety instructions General use Driving on slopes This is what you do Maintenance Children Transport Presentation Release lever SeatFueling Release lever Rider Start the engine DrivingBefore starting Starting a cold engine Driving the Rider Starting the engine with a weak batteryConnecting the jump leads Stop the engine Maintenance Maintenance schedule Cleaning Checking and adjusting the steering wiresRemoving of the machine hoods Checking and adjusting of throttle wire Adjusting the parking brake RiderAdjusting the parking brake Rider 320 AWD Can result in reduced braking ability Checking the fuel pump’s air ﬁlter Replacement of fuel ﬁlterReplacing the air ﬁlter Cool before starting to replace the air ﬁlter Main fuse Check the safety systemIgnition system Checking the tyre pressure Fitting the cutting head Trapping your hand Adjusting the parallelism of the cutting unit Removing the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Service position for the cutting unit Placing in the service positionRestoring from service position Removing the BioClip plug Checking the bladesReplacing the blades Combi 103, Combi Changing the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oil Lubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Troubleshooting schedule Winter storage ServiceStorage Guard Technical Data EC Declaration of Conformity Applies to Europe only Cutting unit CombiBlade 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨ Original instructions