Maintenance
Service position for the cutting unit
The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.
Placing in the service position
1Position the machine on flat ground.
2Apply the parking brake.
3Set the cutting height control in the lowest position and lift up the cutting unit.
4 Release the clip on the front hood and lift off the fender.
WARNING! Wear protective glasses when
!dismantling the cutting unit. The spring which tensions up the belt may break and cause personal injury.
5 Disengage the spring for the drive belt tensioning wheel.
6 Loosen on the cutting height stay and place in the holder.
WARNING! Observe caution to avoid
!trapping your hand.
7 Remove the drive belt and place it in the belt holder.
8Grip the front edge of the unit and pull forwards until it stops.
9Lift the unit until it stops and a clicking sound is heard. The unit locks automatically in the vertical position.
Restoring from service position
1Grip the front edge of the unit and loosen the lock, fold down and slide in the unit.
2Replace the cutting height stay and the belt.
3 Tension the belt with the belt adjuster.
4 Fit the front cover.
24 – English
