What is WHAT?, Location of the controls

WHAT IS WHAT?

1	2		3	4	5	6	7	8
	9	10		11	12	13		14	15

Location of the controls

1	Speed limiter for driving forward	9	Parking brake
2	Speed limiter for reversing	10	Lock button for parking brake
3	Lifting lever for the cutting unit	11	Seat adjustment.
4	Cutting height adjustment lever	12	Lever to disengage the driving front axle, Rider 320 AWD
5	Ignition lock	13	Fuel cap
6	Throttle control/choke control	14	Battery
7	Counter	15	Lever to disengage the drive, Rider 318. Lever to
8	Cover lock		disengage the driving rear axle, 320 AWD.
8	Cover lock

English – 7

Page 7

Image 7

Husqvarna Rider 318, Rider 320 AWD manual What is WHAT?, Location of the controls

Contents

Rider 318 Rider 320 AWD Contents Pre-delivery service Service journalAfter the ﬁrst 8 hours Introduction Symbols KEY to Symbols KEY to Symbols Location of the controls What is WHAT? General use Safety InstructionsSafety instructions Insure your Rider This is what you do Driving on slopes Children Maintenance Transport Presentation Release lever Rider SeatFueling Release lever Starting a cold engine DrivingBefore starting Start the engine Stop the engine Starting the engine with a weak batteryConnecting the jump leads Driving the Rider Maintenance schedule Maintenance Checking and adjusting the steering wires CleaningRemoving of the machine hoods Can result in reduced braking ability Adjusting the parking brake RiderAdjusting the parking brake Rider 320 AWD Checking and adjusting of throttle wire Cool before starting to replace the air ﬁlter Replacement of fuel ﬁlterReplacing the air ﬁlter Checking the fuel pump’s air ﬁlter Checking the tyre pressure Check the safety systemIgnition system Main fuse Trapping your hand Fitting the cutting head Removing the cutting unit Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belts Placing in the service position Service position for the cutting unitRestoring from service position Combi 103, Combi Checking the bladesReplacing the blades Removing the BioClip plug Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlter Checking the transmission oil level Lubricating the belt adjusterGeneral lubrication Troubleshooting schedule Guard ServiceStorage Winter storage Technical Data Cutting unit Combi EC Declaration of Conformity Applies to Europe onlyBlade Original instructions 1156985-26 ´z+X§T¶6X¨ ´z+X§T¶6X¨