STORAGE
Winter storage
At the end of the season, the machine should be readied for storage (or if it will not be in use for longer than 30 days). Fuel allowed to stand for long periods of time (30 days or more) can leave sticky residues that can plug the carburetor and disrupt engine function.
Fuel stabilizers are an acceptable option as regards sticky residues during storage. If alkylate gasoline (Aspen) is used, stabilizers are unnecessary because this fuel is stable. However, you should avoid switching between regular and alkylate gasoline as sensitive rubber components can harden. Add stabilizer to the fuel in the tank or in the storage container. Always use the mixing ratios specified by the manufacturer of the stabilizer. Run the engine for at least 10 minutes after adding the stabilizer so that it reaches the carburetor. DO NOT empty the fuel tank and the carburetor if you have added stabilizer.
NEVER store an engine with fuel in the tank indoors or in poorly ventilated spaces where fuel vapor can come in contact with open flame, sparks or a pilot light such as in a boiler, hot water tank, clothing drier, etc. Handle the fuel with caution. It is very flammable and careless use can cause serious damage to person and property. Drain the fuel into an approved container outdoors and far away from open flame. NEVER use gasoline for cleaning. Use a
Service
When ordering spare parts, please specify the puschase year, model, type, and serial number.
Always use genuine Husqvarna parts.
An annual
To ready the machine for storage, follow these steps:
1.Clean the machine carefully, particularly the chassis and working equipment. Touch up damage to the paint to prevent rust.
2.Inspect the machine for worn or damaged parts and tighten any nuts or screws that may have become loose.
3.Change the engine oil; dispose of properly.
4.Open the fuel valve. Empty the fuel tank (1) and the carburetor (2).
5.Close the fuel valve.
6.Remove the spark plug and pour about a tablespoon of engine oil in the cylinder. Turn over the engine so that the oil is evenly distributed and then refit the spark plug. Put the engine in the compression phase where the triangle mark on the sleeve of the starter is aligned with the upper hole in the starter. Note: Compression phase occurs every second revolution.
7.Lubricate all grease nipples, joints and cables as described in the chapter “Lubrication/ Lubrication schedule”.
8.Store the machine in a clean, dry place and cover it for extra protection.
9.Cover the blade and cutters with a thin coat of oil to avoid rust.
45
