Normal shutdown, Engine switch, Brake | Husqvarna SG13A / CE

OPERATION

Normal shutdown

Throttle

Set the throttle to SLOW/DISENGAGE.

If the engine has been running full out, let it run easily for about 30 seconds to one minute at low speed.

DO NOT let front of unit touch ground until you are sure cutting wheel has stopped turning.

Engine switch

Wait at least 20 seconds, until the blade has stopped.

Set the toggle switch to OFF.

Make sure that the blade is resting against the ground and has stopped completely before doing anything.

Brake

Activate the brake by pulling the lever backwards.

Fuel valve

Close the fuel valve. Turn the lever all the way to the left (see illustration).

Shutdown in emergency situations

Release the dead man’s grip.

Wait until the blade stops.

Make sure that the blade is resting against the
ground and has stopped completely before doing
anything.	8011-186

26

Image 26

Husqvarna SG13A / CE, 968999239 manual Normal shutdown, Shutdown in emergency situations, Engine switch, Brake

Contents

Operator’s Manual Model 968999239 Manual no REV 03/08/04 Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructions Decal Location of decals Translation of instructionsDecal Important information Safety Instructions General use Safety Instructions Preparations Operating Children Movement/TransportStorage Fuel system Maintenance Protective Equipment Personal equipment SET-UP Equipment set-up Hair PIN Engine Main components and operating controls ControlsPresentation 12 11 EngineThrottle Fuel valve StarterStarter handle Choke control Oil dipstick Spark plugMuffler Oil drainage Centrifugal clutch Fuel tankFueling Dead man’s grip bar Brake On/Off Engine switch on the panelAdjustment bar for the handle Never operate a machine with a defective brake Operation Starting the engine Starter handle Engine switch on the handleDead man’s grip bar Shutdown in emergency situations Engine switchNormal shutdown Brake Before you start Using your stump grinder 8011-202chg Transport Shut off the machine when you are doneOperating on hills Maintenance Maintenance schedule Cleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustment Ignition system Fitting the wrong spark plug type can damage the engine Adjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Two minute rule Adjusting the brakeCleaning and washing Lubrication Blade shaft bearings Engine oil Checking the engine’s oil level Right wheel Throttle cable Troubleshooting Symptom Cause Action Problem Possible solutions Winter storage ServiceStorage Technical Data Model Wiring Diagram Service Journal Delivery service Service Journal