SET-UP
Equipment set-up
1.Remove crate top and sides.
2.Remove upper handle bar assembly and lay aside.
3.Open bag containing loose hardware.
4.Using four (4) screws, flat washers and nuts attach the upper handle bar assembly to lower handle bar assembly. See Figure 1.
NOTE: Handle fit is tight. When aligning holes use a tapered type pilot to help align holes (i.e. punch or phillips style screw driver).
5.Attach the position adjusting rod to bracket on the lower and upper handle bar assemblies. See Figure 1.
6.Assemble the compression spring, two (2) flat washers and yoke to brake rod assembly. See Figure 2. Screw yoke onto the rod assembly till rod is even or thru threaded portion of yoke about 1/4” (6.35 mm).
7.Attach brake rod assembly to brake handle on the upper handle bar assembly. See Figure 3.
HARDWARE | WASHERS |
| (2) |
| COTTER PINS |
| (2) |
| UPPER HANDLE BAR |
| ADJUSTING |
| ROD |
| COTTER PIN |
| (1) |
| LOWER HANDLE BAR |
FIGURE 1
| WASHERS |
BRAKE ROD | YOKE |
ASSEMBLY | SPRING |
|
FIGURE 2
WASHER |
(1) |
COTTER PIN |
(1) |
BRAKE |
HANDLE |
BRAKE ROD |
ASSEMBLY |
FIGURE 3
15
