SET-UP
8.Attach the yoke to the brake’s top mounting hole using the clevis pin and cotter pin. Make sure the rod is positioned in the bracket as shown in Figure 4.
NOTE: Adjust the brake before inserting hair pin. To engage brake, pull back on handle until brake rod assembly goes “over center” and locks the brake ON. Turning the yoke clockwise shortens the rod tightening the grip on the brake disc by the brake pads. counterclockwise loosens the clamping force. Proper brake adjustment is such that the wheel will not turn, but slide, when handle is over center.
9.Remove air cleaner and double wire clamp from engine. Figure 5.
HAIR PIN (1) |
CLEVIS PIN (1) |
FIGURE 4
CLAMP |
FIGURE 5
10.Route the wire harness from engine through guide and handle crossmember. Figure 6.
11.Route the throttle cable through guide on lower handle assembly. Figure 6.
12.Connect upper and lower wire harness together. Yellow to yellow and black to black.
13.Push throttle control lever on console forward to full extent. Pull throttle control lever on engine back as far as possible. See Figure 7.
GUIDE |
THREAD WIRE HARNESS |
AND THROTTLE CABLE |
FIGURE 6
16
