LUBRICATION
2. Engine oil
The engine should be warm (but not hot) when changing the oil. Warm oil flows out faster and leaves a smaller quantity of old oil inside the engine.
1.Place a suitable vessel underneath the oil drainage screw. Remove the oil dipstick and the oil drainage screw (5) on the back surface of the engine.
Tip: Make a channel using a piece of cardboard to lead the oil directly into the vessel and avoid soiling the machine chassis.
2.Allow the engine oil to drain into the vessel; then replace the drainage screw. Tighten it moderately.
IMPORTANT INFORMATION
Used engine oil is a health hazard and legislation prohibits disposal on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location. Avoid skin contact; wash with soap and water in case of spills.
3.Make sure the machine is parked on flat ground. Fill with new oil using the appropriate viscosity according to the diagram, API Service
4.Check that the rubber gasket is in position and screw the dipstick back into place. DO NOT thighten it askew or too hard or you may damage the threads.
5.Wipe up any spilled oil.
Checking the engine’s oil level.
Make sure that the machine is parked on flat ground with the engine stopped when checking the oil level.
1.Unscrew the dipstick and wipe it using paper towel or a
2.Replace the dipstick without screwing it in. Remove and check the level on the dipstick.
3.Fill oil as necessary to the lip of the dipstick hole. Oil type, see above.
4.Check that the rubber gasket is in position and screw the dipstick back into place. DO NOT tighten it askew or too hard or you may damage the threads.
WARNING!
Engine oil can be very hot if it is drained directly after stopping the machine. Allow the engine to cool somewhat.
41 |
