Husqvarna ZTH manual Belt Adjuster, Hydraulic Pumps

LUBRICATION

12. Belt Adjuster, Hydraulic Pumps

Lubricate using a grease gun, 1 nipple, until the grease squeezes out.

Use only good quality molybdenum disulphide grease.

Grease from well-known brand names (petrochemical companies, etc.) usually maintains a good quality.

IMPORTANT INFORMATION

Be spartan and remove excess lubricant so that is does not come into contact with belts or belt pulley drive surfaces.

13. Changing the Oil Filter

1.Drain the engine oil in accordance with the work description under the heading Engine Oil/Change Engine Oil.

2.Disassemble the oil filter. If necessary, use a filter remover.

3.Wipe new, clean engine oil onto the seal for the new filter.

4.Mount the filter by hand with + 3/4 turn.

5.Run the engine warm, then check that there are no leaks around the oil filter seal.

6.Check the oil level in the engine, top up if necessary. The oil filter holds 0.2 liters of oil.

8011-575

Lubricating the belt adjuster

8011-570

Changing the oil filter

English-39