I/O Magic DAV-S500 manual 23

	V I D E O O U T	VIDEO IN	VIDEO IN	S V I D E O (DVD ONLY)
						SPEAKER
AM				FRONT	R	CENTER	FRONT	L
	A U D I O O U T	AUDIO IN	AUDIO IN
COAXIAL	L		L
			O P T I C A L	O P T I C A L
			DIGITAL	( C D O N L Y )
FM			IN	VIDEO
	R		R
75Ω
				REAR	R	WOOFER	REAR	L

IN	OUT	OUT	OUT	IN
VIDEO	VIDEO	VIDEO		INPUT
				VIDEO
IN	OUT	OUT
				IN
AUDIO	AUDIO	AUDIO
IN	OUT	OUT
	L	L	OUTPUT
	R	R
			OPTICAL
	VCR	Digital satellite receiver		TV monitor

If you connect a digital satellite receiver with the OPTICAL jack

The digital satellite receiver can be connected to the OPTICAL jack instead of the VIDEO IN and AUDIO IN L/R jacks of the system.

The system can accept both the digital and analog signals. Digital signals have priority over analog signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.

If you connect a digital satellite receiver without the OPTICAL jack

Connect the digital satellite receiver to the VIDEO IN and AUDIO IN L/R jacks only of the system.

Setup for the system (for Asian and Australian models)

Setup is necessary for the system, depending on the TV monitor to be connected. The initial setting for Asian models is NTSC but Australian models is PAL.

If the colour system of the TV is PAL*

To set the system to PAL, turn on the system by pressing 1 (power) on the remote while pressing X (pause) button on the system. You need to hold the X button until DAV-S500 appears on the display. To reset to NTSC, turn off the system and then turn on again using the remote while pressing the X button on the system.

*If the colour system of the TV is NTSC, do the same operation above to set the system to NTSC.

Connecting the AC Power Cord (mains lead)

Before connecting the AC power cord (mains lead) of this system to a wall outlet (mains), connect the speakers to the system (see page 17).

Connect the AC power cord (mains lead) of your TV/video components to a wall outlet (mains).

Started Getting

23