TROUBLESHOOTING
SITUATION
POSSIBLE CAUSE (REMEDY)
SPRAY MATERIAL LEAKS AT PRIME VALVE STEM
1.Prime valve stem packings (ref# 38 or 39) defective. (replace damaged packings following detailed instructions on page 25.
SPRAY MATERIAL LEAKS OUT PRIME VALVE HOSE WITH VALVE CLOSED
1.Prime not closed tightly. (tighten valve handle (ref# 43) further)
2.Prime valve worn. ( install prime va lve repair kit, (ref# 47). See page 25 for detailed instructions.)
SPRAY PATTERN IS SPOTTY OR UNEVEN
1.Pressure is too low. (increase pressure slowly until problem is corrected ).
2.Spray material too thick. (thin as recommended by material manufacturer).
3.Plugged siphon screen, siphon tube, gun filter or a combination. (inspect and clean or replace as required).
4.Plugged tip. (remove and clean tip).
5.Pump malfunctioning or unsuitable for the material. (refer to other areas of troubleshooting guide and check material requirements vs 300S/SL output abilities).
SPRAY PATTERN LEAVES LINES OR FINGERS
1Pressure too low. (increase pressure slowly until problem is corrected).
2Worn tip. (replace tip).
3Tip too small for spray material. (change to larger tip or increase pressure. See material manufacturers recommendations).
EXCESSIVE OVERSPRAY OR FOGGING
1.Pressure too high. (reduce pressure as required).
2.Material too thin. (follow material manufacturers recommendations
3.Tip too large. (reduce tip size).
4.Improper application technique. (refer to proper application techniques on page
5.Too windy. (wait for wind to let up).
H.E.R.O. INDUSTRIES | 22 | 300S / 300SL LEGEND Owner’s Manual |
