3
NOTE: The Server Switch Modules do not connect to each other within the BladeCenter chassis. To connect the modules to enable features such as subnet manager failover, connect the modules with an IB cable via the external connectors. Before you connect the two Server Switch Modules in your chassis, configure the priority of the subnet managers on the modules. For step by step instructions, refer to “Connect Beyond BladeCenter” on page 8.
Management
You can manage your Server Switch Module with any of the following interfaces:
•Simple Network Management Protocol (SNMP) versions 1, 2, and 3 with Topspin’s Management Information Base (MIBs)
•TopspinOS command line interface (CLI)
•Chassis Manager
•Element Manager
•APIs (via SNMP)
For instructions that detail how to configure your Server Switch Module with the CLI, refer to the Command Line Interface Reference Guide. For instructions that detail how to configure your Server Switch Module with Chassis Manager, refer to the Chassis Manager User Guide. For instructions that detail how to configure your Server Switch Module with Element Manager, refer to the InfiniBand User Guide.
LEDs
The Server Switch Module provides module status LEDs and port status LEDs. Figure
NOTE: External port numbers begin at 15 because ports 1 through 14 are internal.
status “OK” LED |
|
|
| status “fault” LED |
|
|
| ||
4x port 15 link LED |
|
|
| 4x port 15 logical link status LED |
12x port physical link status LED |
|
|
| 12x port logical link status LED |
4x port 16 physical link status LED |
|
|
| 4x port 16 logical link status LED |
4x port 17 physical link status LED |
|
|
| 4x port 17 logical link status LED |
4x port 18 physical link status LED |
|
|
| 4x port 18 logical link status LED |
